Aftermarket Key Blank for Opel / Vauxhall

Transponder: Not Included
Key Blade: HU46
ISN: 3543
Silca Card: 110

This key is without transponder chip. It can be fitted with all types of transponder, wedge (4C / CN2 / CKG), large glass (4D / TPX / GTI) and and small glass (Megamos, Sokymat, TS48).

The key can be supplied either blank (uncut) or cut to your vehicle. To find out more about our cutting service please see the ‘Key Cutting Information’ tab above.

Suitable for the following models:

Opel / Vauxhall Agila (2000 - 2004)
Opel / Vauxhall Astra (1991 - 2005)
Opel / Vauxhall Calibra (1989 - 1997)
Opel / Vauxhall Carlton (1995 - 1998)
Opel / Vauxhall Combo (1993 - 2004)
Opel / Vauxhall Corsa (1993 - 1998)
Opel / Vauxhall Meriva (2002 - 2004)
Opel / Vauxhall Speedster (2000 - 2005)
Opel / Vauxhall Tigra (1995 - 2002)
Opel / Vauxhall VX220 (2000 - 2005)
Opel / Vauxhall Zafira (1999 - 2004)

Dates are given as a guide only and we cannot take any responsibility for incorrect part compatibility. If you are unsure if this is the correct part for your vehicle please fill in our Parts Enquiry form and we will confirm the correct part number for you.

Note:

This is a mechanical key. There are no electronics inside. If you require a transponder or remote key please see our other items. 

Trade Customers:

Customers who are in the locksmith or motor trade may register for a trade account. Trade account customers get preferential pricing and loyalty discounts. Please register using the link at the top of the page to find out more.

Keys Cut to Key Number

We can cut keys to the manufacturer's key number (often referred to as the 'key code'). For this particular blade the key number will usually be written on the 'Car Pass' (a credit card sized piece of card labelled 'Car Pass') and will start with one letters followed by four numbers, e.g. Z1234.

NOTE: The key number will not be on the key itself. The key number is NOT 3579.

Keys Cut to Photo

If the option for 'Cut to Photo' is shown in the key cutting drop down box we can cut the key to a clear picture of the blade. The blade should ideally be on a white background with the end of the blade facing towards the right. The picture should not be blurred and the cuts of the key should be easily identifiable. You can see an example picture here