Genuine Mazda Smart Remote Key Blade 

Mazda Part Number: D6Y1762GXC 
Transponder: 4D - ID63 6F
Profile: MAZ24R
ISN: 424
Silca Card: 288

Genuine Mazda key blade supplied with the original manufacturer packaging.

This key blade comes complete with transponder chip and can be supplied either blank (uncut) or cut to your vehicle. To find out more about our cutting service please see the ‘Key Cutting Information’ tab above.

Suitable for the following models:

Mazda 2 (2007 - 2012)
Mazda 3 (2008 - 2013)
Mazda 6 (2007 - 2012)
Mazda CX7 (2009 - 2012)
Mazda CX9 (2009 - 2012)

Dates are given as a guide only and we cannot take any responsibility for incorrect part compatibility. If you are unsure if this is the correct part for your vehicle please fill in our Parts Enquiry form and we will confirm the correct part number for you.

IMPORTANT:

The key will need to be programmed before it will start the car and open and lock the doors remotely. Please see the 'Key Programming Information' tab above for guidance on who will be able to program this key type.

Trade Customers:

Customers who are in the locksmith or motor trade may register for a trade account. Trade account customers get preferential pricing and loyalty discounts. Please register using the link at the top of the page to find out more.

Keys Cut to Key Number

We can cut keys to the manufacturer's key number (often referred to as the 'key code'). For this particular blade the key number will usually be in the service book and will normally consist of five numbers, e.g. 50001.

NOTE: The key number will not be on the key itself.

Keys Cut to Photo

If the option for 'Cut to Photo' is shown in the key cutting drop down box we can cut the key to a clear picture of the blade. The blade should ideally be on a white background with the end of the blade facing towards the right. The picture should not be blurred and the cuts of the key should be easily identifiable. You can see an example picture here.

Keys Cut to VIN (Chassis Number) - European Vehicles Only

We can cut the key to your VIN and supply you with the key code. To do this we require a copy of the inside page of the logbook / ownership document, detailing the vehicle's registration, VIN and vehicle owner's details. The vehicle owner's details must match the delivery address details when placing your order. Please scan or take a clear photo of the log book and upload it using the ‘upload a photo’ option.

IMPORTANT: Keys cut to VIN will be cut to the original locks of the vehicle. If the vehicle has previously had the locks changed then obviously this key will not work. Keys cut to VIN are non-refundable.